Re: Farmall H engine
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk ]
Posted by MM on June 07, 1998 at 19:33:56:
In Reply to: Farmall H engine posted by Mike on June 07, 1998 at 09:12:55:
: I am in the middle of a rebuild on my '42 Farmall H and would like to know why the engine seems to get harder to turn over by hand as I tighten the engine mounting bolts. The clutch, pressure plate, throwout, and pilot bearings are new, and the flywheel has been resrufaced. When installing the block, the engine will turn freely, until the gap between the clutch housing, and the backer plate is about 1/16" apart. Then as I tighten the rail bolts, and the bolts from behind, I can feel the crank get harder to turn every time I give the bolts another turn. When the gap is completely closed, I can no longer turn the crank by hand. Thanks,for any help. You must have some kind of thrust problem. The input shaft of the transmission must not be going into the clutch easily enough or into the pilot bushing easily enough. Did you check these before you put the clutch together? Did you use a clutch aligning tool when you assembled the clutch?
MM
Follow Ups:
Post a Followup
|
