Posted by LOU from Wi. on March 25, 2013 at 19:24:55 from (174.124.8.216):
After firing the derringer and 45 single action revolver, my son discovered that when reloading the shells, the bullets went way to deep in the casings that was fired from the derringer. Only five showed that kind od expansion. Son miked the chambers of both the derringer and the 45 single action 45, measurement occured at the chamber where the casing stays,not the rifling where the bullet follows. Two different shell manufactures =Winchester/ Starline was fired. Starline held their shape when fired in the derringer but winchester casings allowed the bullet to sink way to deep when reloading. Have any of you re loaders come upon this problem? Would like to hear from those who experienced this problem. Regards LOU.
P.S. The Winchesters were factory loaded first, we fired those and this is the first reloading attempt on the winchester shells.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.