Posted by nickg on March 26, 2013 at 07:56:13 from (96.27.166.131):
In Reply to: Reloading safety.Pics posted by LOU from Wi. on March 25, 2013 at 19:24:55:
your problems are in your brass and sizing. Full length size,full length size,full legnth size.Winchester is a light brass. Starline is actually made at the same plant the winchester's are but seem to be a little harder brass. Derringers are bad about over expanding the cases. Thats a lot of heat and force in a short barrel. Measure the empty case and make sure its still with in the sami spec or if its been strecthed. Just because it was factory ammo does not mean its new or even once fired unless you buy brand new empty brass you never really know.Full length size every time.Guys will argue it shortens brass life which I can see there points, but I feel its a must every time you load. It only takes a minute and you can avoid troubles like these.Make sure your not overcharging the cases as well. You very well mite find that 8 grains of powder is fine in the revolver but to much in your derringer. Before you run your case threw the expander die check and make sure the bullet doesnt drop in to far or youll have to resize again or throw that cartriage away. Not having a crimp on a bullet will cause it to come farther outa the case not further in and I read it to be that your having troubles with bullet seating depth before you even took the reloads to shoot. A good reloading manual should have all your cartriage specs and acceptable lenghts. If you dont have it I highly recommend sierras 5th edition or speers reloading manuals.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.