Posted by fixerupper on April 14, 2013 at 06:07:01 from (100.42.82.30):
In Reply to: sandblaster. posted by charlespretzer on April 13, 2013 at 05:47:45:
I stand by what I said about needing a $2000 compressor and the need to give it a rest and using an 1/8" nozzle because I AM the owner of the compressor and sandblaster. I have a 17 CFM and a 30 CFM, both high dollar. I'm the one who pays the bills here and I'm the one who has to cough up the money to replace the compressor if it burns up. My post also reflects my frustration with the deceptive advertising and misrepresentation cheap tool companies use to sell their inferior products. I was sucked in by Sears once on an advertised 3HP table saw that was in reality only 1.5 HP and I've never forgotten it and I don't want someone else to get caught up like I did. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
