Posted by Stick welding on April 14, 2013 at 11:32:07 from (96.53.210.246):
In Reply to: Re: sandblaster. posted by fixerupper on April 14, 2013 at 06:07:01:
Thank you fixerupper! I apologize to the original poster and others who had to read all the off topic crap. In my original post I gave my honest opinion that you should have a heavy duty compressor if you intend to do sandblasting. I wasn't giving this opinion just so the poster could spend a lot more money. Sandblasting is hard on a compressor and I didn't want to see the poster destroy his compressor. Many lighter duty compressors have been destroyed by trying to do the work of a heavy duty compressor. I have a Webster model 55 compressor that needs some repairs due to sandblasting and it's an industrial duty unit. Kind of the same as using a farm loader in the same application as an industrial loader. Sooner, rather than later you're going to run into problems. Problems cost $$$$. I was trying to save the OP from problems. Sorry to drag others into my beef with Lou.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
