Posted by John in La on June 23, 2013 at 22:18:30 from (184.38.218.16):
Needed to add some R134 to my truck. Go the parts store to get a can and ask.....
Do you have adapters that convert R12 hose to fit the R134 fittings as I have a set of R12 gauges. NO
Do you have a set of R134 hose since the fitting that hooks to the gauge set is the same for R12 and R134? NO..... But we do have a set of R134 gauges and hose to loan out. $100 deposit and you get all of it back when you bring the gauge set back.
OK sounds good. Give me 2 cans R134 and the loaner gauge set.
Salesman gets a gauge set and small can adapter off the for sale display shelf. I say uh excuse me I wanted the loaner set. Then I notice these pieces look like they have been open before. He proceeds to ring up the gauge set and adapter like I was buying them. Opens the package and gives me the tools to use.
I install the R134 in the truck right in the parking lot and take the gauge set back inside when finished. He puts it back in package; puts a little tape on it and puts it right back on the for sale shelf; then rings up the gauge set as a return and refunds my money.
Now I have never used loan a tool before because I usually just buy the tools I need. Just could not see spending $100 on a gauge set to install 1 can of R134 especially when I have a gauge set that will work if I buy the proper hose set.
Just seemed odd the way they handle loan a tool. I for sure will not be buying any tools from this place because I expect NEW UNUSED tools when I pay full purchase price.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
