Posted by Super A on October 02, 2013 at 18:39:21 from (64.24.115.172):
I recently acquired a #6 IH hammer mill in pretty good shape.
These mills are driven by a long, flat belt. I"ve never run anything with a belt pulley before, so I"d like some input from those who have been there and done that. My plan is to demonstrate it at shows. Here"s what I "think" I know:
1. Long belts stay on better if they run slack
2. Everything has to be lined up just right.
3. You have to put belt dressing on the belt
4. It is cooler than heck watching a belt driven machine run.
That"s about it. It looks like (I have not measured the pulley) I need a 6" wide belt. Looks like there are plenty of different lengths on Ebay. How long a belt should I look for? Basically, I need a "belts for dummies" lesson.
I plan on running it with a smaller tractor like a Farmall Super A. (I don"t plan to crowd it too much) Does the size tractor I use help determine the length/type of belt?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
