Posted by Had It Up To Here on December 27, 2013 at 17:19:59 from (71.89.177.192):
I have just spent a couple of months turning an ugly 47 Ford 8n into what looks like an almost new tractor now. I did this because I lost my job and I am going to have to sell this to hopefully keep me going till I can find work....... yeah, well... went out all proud with my boys today. Rolled it out of the barn, put gas in it and jumped it. Yeah, it will start EVEN THOUGH you cannot push the starter button in! The starter keeps spinning so obviously, I have a wire wrong. The REAL problem though is that it is in neutral and you can roll it around all over but it wont seem to go into gear. I did A LOT of work to this tractor but I NEVER TOUCHED anything to do with the transmission. How in the $%@$#% can a piece of steel sit idle and break itself. I am on the verge of taking a walk on the Golden Gate Bridge if you know what I mean..... What can you tell me?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.