Posted by LOU from Wi. on May 25, 2014 at 21:02:42 from (184.158.21.8):
As a diabetic, it is going to take a little more time than usual to heal. Non diabetics, healing will go faster using a salt water mouth wash solution does help, but my mouth is still sore.I am bound and determined to use my teeth when the mouth heals up, I can eat most everything now except pickles. What I miss the most is the flavor of food when the uppers are put in. My last visit with the dentist, they did polish out the tops so they weren't quite as thick, been googling tooth extractions and diabetes. Seems like it is going to be a little over 30 days for enough healing to be able to start using my choppers. I was wondering if other diabetics has had that problem here on yesterdays tractors?
Teeth sure look nice when I got them in,however its been short stints up til now. I have to have them ready when the corn shows on the cob and apples show on the tree.I hope it's not wishful thinking to be able to eat corn on the cob, apples, cucumbers and radishes.
The garden is coming along nicely,lots of plantings are showing their heads thru the soil.So it's a race to see which gets ready first,teeth or fresh garden veggies.
The eye surgeon is coming down from Ashland to evaluate the cataracts in June 23rd,as of now my eyesight is closing down due to the cataracts. It will be nice to see again,so my son don't have to read everything to me,bless his heart. I don't think the diabetes will be a deterrent, at least I hope not. It is one he@@ of a nasty disease,anyway I would appreciate any information from you folks,if you are diabetic and undergone both dental and eye procedures you have gone thru with success. Would appreciate hearing about it. Regards, LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
