Posted by mkirsch on August 21, 2014 at 10:42:10 from (72.45.143.81):
In Reply to: Spare Tire Rant posted by John T on August 21, 2014 at 09:07:51:
If you can wiggle the wheel around to where you can see the winch through one of the holes, you should see that the tire hanger has a shank that inserts into a socket on the winch. Part will be black, part will be silver. The silver part contains a notch that latches into the winch body.
The silver part retracts sideways into the black part, releasing the latch and allowing the tire to drop.
What has happened is the silver part and the black part have become dirty/corroded, and will not slide against each other.
In one instance, I had to reach up through the tire with a conglomeration of wrenches and detach the bolt holding the winch to the truck frame. Once I had the tire and winch out from under the truck, I was able to force the latch to release. It's only one bolt, but it can be fun to get to. Also once the bolt releases, the tire falls on your head.
The second time it happened, I was able to insert a long screwdriver up in there and pound the silver piece into the black piece until the latch released.
After that, I ground the notch off the silver part, so the spare is now only held by the cable.
It's a stainless cable, and it's been that way for several years now. The spare is still there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
