Crazy Horse said: (quoted from post at 15:41:38 09/18/14) We have a Case 1410 (David Brown 1410) tractor and would like to be able to adjust the height of the radiator a wee bit to clear the hydraulic pump shaft a bit more which is below the lower rad tank. The shaft is rubbing a wee bit on the tank. Not much leeway to fiddle with between the 7-blade plastic fan and the radiator tin shroud. Can we trim back the 7 blades about 1/4" each (carefully and accurately) without worrying about fan efficiency or balance issues? Comments or suggestions are appreciated.
Hi I was wondering if you got the pump on the front mounted to high or changed the shaft and the new one is slightly bigger diameter,causing it to rub.
There has to be something wrong here thats changed recently.
Not trying to be ignorant, but try fixing it properly Hacking stuff up is not the solution. You should see some of the cutting torch fixes I get in my shop for this stuff. When I do other work in that area I usually find the problem was pretty simple, and the last thing it needed was Cutting to bits and absolutely wrecking good tin or tractor parts!..
Regards Robert
This post was edited by Robert Major at 21:47:29 09/18/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
