Posted by NCWayne on February 05, 2015 at 19:53:14 from (173.188.169.54):
In Reply to: Axle limit question posted by bradyw on February 05, 2015 at 19:34:12:
From looking at it I'd say the axel might hold the 8000 lbs without much problem. I know the axels on my trailer are rated at 7500 lbs and they aren't anywhere as heavy as what your describing.
That said, there's no way I'd want to be towing an 8000 lb load on a single axel, with only a single wheel on each side. One with the single axel, it would be extremely difficult to position a machine on the trailer and establish a correct loading on the tongue.
Moving on to the tires, and most importantly, you need to see what the load rating on them is. I know most big truck tires are rated around 5500 lbs on a single wheel. This would, technically, give you the capacity needed, but that would only cover a static load. Remember, if you hit a hard bump/pothole and the trailer jumps, etc, it's going to be coming back down/being jarred with far more force than just the 8000 lbs actually on it.
This leads me to what would be my biggest concern, having a tire blow out. With that much weight, a blowout on a trailer with only one axel and one tire per side, holds a HUGE potential to be deadly, for both the driver of the tow vehicle, as well as those around him.
In the end, if I were in your position, I'd either buy, or build a trailer that would haul the load safely, or find someone to haul it for you, as I don't think what you've got will do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
