Posted by Bill Va on March 01, 2015 at 12:34:52 from (70.208.141.95):
This is probably some of the nuttiest questions I've asked in a while, so forgive me they are...
In our hayfield revitalization plan this upcoming year, the plan is to spray everything with 2,4-D in mid April to knock down the weeds and cut the hay in mid May (if possible), again around the 4th of July and again in mid to late August. At that point, we plan to kill everything down to dirt and start over.
I've been doing a bit of reading and it sounds like one can mix 2,4-D with some liquid fertilizer (type TBD) and in doing so, get the weeds to launch into a growth spurt and really suck-in the 2,4-D for a better kill. The rest of the grass hay would benefit to some extent from the liquid fertilizer. The aftermath would hopefully give us some hay with considerably fewer weeds as well as a bit higher yield.
Anyone had any success with mixing 2,4-D and a liquid fertilizer?
With the whole burn down to dirt and start from scratch plans, one of our biggest challenges and expenses is that our farm geographically is in a bad spot relative to lime and fertilizer co-op places (read long distances) as well as seed drill rental. This makes their stuff very expensive just due to the distances and some won't deliver at all.
I don't see any of getting around lime, but fertilizing going forward - is some type of liquid fertilizer with my 50 gal/3pt sprayer a realistic option? Today is 12 acres, maybe as much as 30 in a few years.
Drilling seed, just due to rental distances is going to be a challenge too. One of the things I've thought about, which runs counter to our plans, is knocking down the weeds, forgetting about a burn down/start over and making due with the fields as they are. With that approach, we'd try some kind of broadcast and or frost seeding - looking at over time having one dominate grass from our efforts. If a liquid fertilizer is a real solution and not a gimmick, then I've got the equipment to go this route and wouldn't have to depend on the co-ops, other than lime.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Good As New - by Bill Goodwin. In the summer of 1995, my father, Russ Goodwin, and I acquired the 1945 Farmall B that my grandfather used as an overseer on a farm in Waynesboro, Georgia. After my grandfather’s death in 1955, J.P. Rollins, son of the landowner, used the tractor. In the winter 1985, while in his possession the engine block cracked and was unrepairable. He had told my father
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
