Posted by NCWayne on March 08, 2015 at 09:50:29 from (173.188.169.54):
In Reply to: No metric wrenches? posted by Notjustair on March 08, 2015 at 07:43:49:
I just replaced the front engine cover on a 6400 JD. The majority of fasteners on the engine were standard, but the fasteners on the sheet metal, etc were all metric.
The topper in the whole deal, to me, was the 3 fasteners that held the belt tensioner on. The bolt end that went into the engine was a standard 3/8 coarse thread, but the stud attached to the head of the bolt was metric. In other words you had both standard and metric on the same fastener.
Along those same lines, you've got to look out for standard fasteners with metric head stamps. I've fun into quite a few bolts that had standard threads, but the head stamps were either the usual 8.8, or the 10.9's that you usually see on the metric stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.