Posted by dhermesc on July 27, 2015 at 08:22:17 from (24.248.193.103):
I recently bought an older (1990) F150 that was in excellent condition for my teenage son to drive. AC was dead and I paid a shop to convert to R134 and recharge. They charged me $200 for the conversion and recharge. The charge lasted about 3 hours before the AC was blowing hot air again. Brought it back to them and they said the condenser had a hole. The said they'd need about $500 to replace the condenser and recharge.
Question - shouldn't they have caught the hole in the condenser (or at least that the system was leaking) when they put a vacuume on the system to purge the R12? I thought the $200 was a bit high - but thought it was worth it to have it done right - up until I found out it was wasted. Seems almost like I could have bought the conversion kit from Wal-Mart and charged it for all the good they did.
The condenser is $74 and looks not to difficult to install. Do it my self and have a better shop evacuate the system and charge?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.