The only way to put fertilizer on corn or beans in rows is with the planter puting the fertilizer 2" to side and 2" below the seed, the older planters put it above the sead with a bit of soil between, worked but not as good as below and to side of seed. If corn put all three on with planter and for extra nitrogen come back when corn is 12" tall and sidedress. For beans drilled only way you can do it is broadcast either before last working of ground or with drill as you plant. It is comming in the next couple of years if not already in place by law that you cannot apply P any other way. Just look at Ohio and Michigan and that last year Toledo had to shut down its only source of drinking water because of the phosferous (? spelling) It is noe ileagal to spread manure in what is considered winter months in my local area. I could still do it on my ground but 20 mile away you cannot do it and have to stockpile it. There is going to be no fall applying fertilizer in just a couple of years because of runoff. Only think you can safly put on this fall is lime for those crops, noe if you would be making hay then I think you could fertilize it as hay crop this fall, might do some good but probably not as too late for plants to be able to abbsorb it before going dormant. That would depend on your growing season and here could get that killing frost any day, a lot of years we would already have had it and after that do not apply any fertilizer.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
