Posted by brent zappe on October 08, 2015 at 06:53:12 from (69.230.49.150):
Lately I have been thinking if I sell my land to a UNiversity. Where I would move and what type of shop I would like to build on the property. I first thought that an 80 foot by 80 foot shop would be nice with 15 high doors to put big equipment inside. Then I thought to have a paint both inside of the shop. Then I thought that haveing a little office space with a bathroom in the shop would be a nice thing to have.So I would not have other people in my house useing the bathroom in the house. My Hobbie is growing around me and I enjoy it. I have this bug of restoreing old cars, trucks and farm equipment. When I sell to the University I am going to move out of the area I am now liveing. The city has grown to big and is pushing all of us out so my question is? What is a good working shop lay out to have for a person who has a hobbie like this? Can you give me some examples on what you might have in your shop that you find is the best thing to have.I hope you enjoy the pictures of some of my work I have done. Thanks Brent..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
