I built a 42X95ft steel pole building and had them put a wall at 32ft so my shop is 42'X32'. Then I had an overhead door installed in that wall so I can move stuff from the shop to the shed without going outside. I put in radiant overhead heat. That's the best move I made. In my opinion, forced air is a total waste. Radiant heats the objects in the shop including the floor. Very comfortable and constant temp. I turn the heat down for the night and the next morning, in a few minutes, the temp is back up to where I want it. I laid down plastic conduit before the floor was poured so, almost all of my wiring is under the floor. That way there isn't much conduit on the walls. One building with a shop and shed. Less expensive than two buildings. To get in and out, I have an overhead door on the shop and two sliding doors on the shed. Had it for six years now and can't think of a thing that I would change except because of snow, if I had to do it over, I would put the sliding doors inside instead of outside.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.