Posted by Cariboo4x4 on October 09, 2015 at 21:24:19 from (96.44.122.150):
I bought this old hydraulic cylinder. I tested it with air and it extends when you blow air into base and retracts when you blow air into piston rod end. My questions are I wonder what this cylinder was used for? And secondly the piston rod is 2.5" in diameter and outside of cylinder is 3.5" in diamter. I wonder if I could use it on a scissor lift for an 8' dump box? I have a single stage hydraulic pump ( pumps a lot of oil quickly) or should I use a dual stage pump like the one on my wood splitter? I have a gear box to bolt to my transfer case transmission in this GM one ton 4x4 chassis. Curious to know what the cylinder was used for in the past especially with how oil enters piston rod end. [URL=http://s65.photobucket.com/user/godtool/media/Mobile%20Uploads/2015-10/EE2BDE51-7C0F-4E98-82D5-A9944F3F67A4.jpg.html][/URL]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.