Posted by John in La on November 07, 2015 at 19:18:55 from (96.33.136.54):
For several years I have considered bulldozing my old shed down and building a new one. The foundation is not good; termites have gotten in the walls; and you could take a shower in there with all the condensation falling off the metal roof.
I have seen you post several times about the shingle roof on your shop. I assume it is on trusses 16 or 24 inches on center. What I would like to know is what kind of walls do you have and how are they built to carry the weight of the shingle roof. Especially interested to find out if you have steel walls and if so How do you like them.
I would like to build a 24 or 28 foot square shed with a shingle roof but have not decided how I will build the walls. Any wood in contact with the ground has to be UC4C or UC4B treated to .60. Normal lumber yard pressure treated wood will not do.
What I really need is a stick built garage but the concrete slab has priced me out of building it so I keep putting it off and just using my old shed I have thought about (even priced it all out in the past) going with a post frame and steel walls over house wrap or tar paper; with post 8 feet apart and a double 2x12 header at the top of the post to hold up the roof but UC4C treated to .60cca post are very hard to find and really cost a lot per pole and I really am on the fence about using steel even for the walls. I am now thinking about putting a 12" x 12" x 36" tall concrete footer in the ground and setting either a double 2 by header across the footings and stick building from here up; or just putting 6x6 post on the footings and building it like a post frame building.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.