Posted by Bill VA on February 27, 2016 at 09:24:02 from (216.24.79.193):
Me and the boys went out EARLY this morning while everything was frozen to cut a jag of firewood. Had a few what can go wrong can go wrong delays and the ground started to begin thawing.
Along the road we have into a section of woods, it has always been a little damp as it is at the bottom of a hill and flat a but NEVER had any trouble going through, even if it's raining. Not so today. Recently we clear cut the hill side above the road and the runoff goes straight to this section of the road. Before I realized what I was dealing with - bam - stuck and no 4x4 was going through it, including mine!
Hiked back to the tractor shed and got the JD and chains. Pulled alongside my stuck jeep (we use a jeep with trailer for hauling wood) far enough up hill where it was solid and yanked the jeep and trailer out of the mud - no problem.
Never encountered quick - quick sand type mud with no apparent bottom as long as I've been driving off road. Today was a first! Once I started spinning, I knew I wasn't getting out - so I quickly shut down the jeep - rather than bury it to the frame and make matters worse.
I've seen plenty of pictures over the years of farm tractors up to the frame, even 4x4 models in fields while plowing.
Didn't get any wood, but definitely had a teaching moment with my boys. First hand experience with quick, bottomless mud, second, 4x4's are not invincible and can be stuck. Third, once you atart spinning - stop or you can make matters worse.
Anyone had a similar experience? What did you get stuck and how did you get it unstuck?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.