Posted by Dave H (MI) on April 29, 2016 at 09:02:29 from (50.33.246.137):
...happen in the back of the field? Or running out of gas on an old tractor without a gauge? Seems to me I would have a better chance of winning the lottery than having a tractor stop running up by the road. I was just telling another forum member in an e-mail how my planting season is going. Just replaced a hydraulic hose on the 1586...easy...two connections. Except half the county musta blown a line this week because there was a wait to get a new one and the tractor was more than a quarter mile back in a field that was dry when I started...not so much now. I new I would play the devil getting that chisel back on the tractor (by myself) if I unhooked and limped up to the shed. So I worked on it right where it was. Pull up the floor, stand on your head/hang from your ankles, fight with a fuel line and wire harness....
Works now! Back up to the shed. Waiting on some sun to dry things out/warm things up a bit. Guess I'll see what is ailing the old corn planter that I had not anticipated. Rant over...maybe...
And people think I get cranky during tax season!?!? This is the life I chose.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
