Posted by Doug-Iowa on September 21, 2016 at 06:35:30 from (216.248.81.129):
In Reply to: F134 Jeep Engine posted by Doug - Iowa on September 20, 2016 at 16:45:19:
So I notice this morning I had a serious typo in the title. This engine is a L134 not and F134. I have Jeeps with both engines, and wherever I get talking about the old Flathead I throw that F in there when in fact it is called "L head". The "F head" is for the newer engine with the intake valves in the head and the exhaust valves in the block. Now that my mistake is cleared up, we did make progress after I posted last night.
My son pulled the oil pump and indexed it correctly last night. After that he was able to get the timing better adjusted and the heating problem went away. Just need to recheck the valves and we should be good to go. Everyone has a different feel for setting valves, if you have a preference would it be to have them a little tight or a little loose? Its titled as a 47 CJ2A but who knows what the engine is. Has a willys block and a ford head, and when we ground the valves two of the exhaust had been up-sized to intake seats. So I'm pretty sure its a pieced together engine. But no big deal, even the old mil-spec MB's were pieced during depot overhaul. Head is marked .014" but I have TSB's that say .016".
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
