I would start talking to some local bin companies to find your alternatives and make some comparisons.
What would two new bins cost if: 1. the bin company builds them from scratch or 2. if you pour the concrete pad and assemble the bin yourself? I would not want to invest over 40 percent of new cost for almost 30 year old bins and equipment.
Can a drying fan be added to one of the bins and what would it cost? If you are pouring new pads for the bins and installing new wiring to the bin site, now would be the time to build an air plenum into the pad and wire the site for a drying fan, probably 5 HP minimum. A 7.5 HP dryer would give you more drying capacity or allow you to dry with less heat, reducing your fuel costs. Keep in mind that taller columns of grain restrict air flow more. Drying bins are sometimes run as batch dryers, they are emptied often to keep a with a wide, low column of grain until all the other storage is filled.
Are there any local bin moving outfits that can move the bins for less that you can do it yourself?
Would one larger bin cost significantly less than two smaller bins?
Do as much research as you can on grain drying before you build a new bin site.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
