Posted by John T on December 21, 2016 at 06:18:02 from (71.54.163.172):
In Reply to: John T posted by Rollie NE PA on December 20, 2016 at 17:23:19:
A big shop in Austin Texas had it a week, I told them ODBI said cant communicate after cigarette lighter outlet smoked, after a week (don't think they ever looked under the dash) they TOLD ME COMPUTER WAS BAD WASNT WORTH FIXING..................Towed it back to Florida took it to Alan Jay Chevrolet they said they would have to remove dash and replace burned wiring harnesses (their scanner failed to communicate as I told them it would) would cost a thousand wasn't worth fixing (I don't think they looked under the dash either, charged me $100 for diagnosis) and called a salesman over to sell me a car..........They would pay $100 for the car as is for scrap metal!!!!!!!!!
Just outside our RV park is a small garage mechanic who lives in a house trailer and works in his carport and told him how scan cant communicate and the cig lighter outlet had smoked but I replaced fuse and it held. Left car there and stopped by 30 mins later CAR WAS FIXED AND RAN PERFECT AND ALL ELEC WORKED !!!!!!!!!!! He said the ODBI port had no power, ONLY the one cig lighter wire was burned NOT any harnesses, he repaired the circuit and removed the short, unhooked battery to let computer reset RUNS PERFECT AFTER SEVERL TEST DRIVES I ask what I owe HE SAYS IS $40 OKAY !!!!!!!!!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.