Posted by farmall706guy on February 09, 2017 at 07:04:13 from (198.110.57.200):
Hey all, I have finally bought my 7.3 power stoke glow plugs, I dyed/rethreaded the glow plugs so they fit, and i got all 6 glow plugs in the tractor. All I did for wiring was I bent the old slab connectors into a round hole, and they fit right onto the new 7.3 glow plugs. My electrical setup is all brand new straight 8 gage wire coming from the 12 volt batteries right up to a heavy duty push button switch, then 8 gage wire all the way to the glow plug junction. I have each wire to the glow plug wired separately up to the junction, so they each all have even distribution of power. My main question here is how long should i have my finger on the glow plug button switch before I would chance burning them up?
I bought the glow plugs at auto zone. not online.
anyways, my question is how long do all the sensors and relays activate the plugs for in a normal ford truck? since i don't have all those relays and stuff, I AM the relay, if you know what i mean. if the plugs are only activated for 15 seconds, or even less, thats perfectly okay, I will just let the block heater run for 4 hours instead of 2 hours, if you know where I'm coming from. thanks guys for any help. Note: i am working in 18 to 34 degree Fahrenheit weather. Here is the link to the exact glow plugs
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
