Posted by DeltaRed on August 08, 2017 at 11:59:48 from (65.100.147.23):
In Reply to: M Farmall #BK168377X1 posted by GHighPriest on August 08, 2017 at 09:39:09:
AFIK,IH never made a 'factory' propane M. ths first 'factory' propane was super M.The Sn (I think) is a Louisville tractor/Sn.The disk brakes were Sm. M had band brakes from factory.However some Ms were fitted with aftermarket 'Lambert'disk brakes.Is the tank mounted lengthwise,or crosswise?Pretty sure a 'factory' SM had the tanl mounted crosswiseYou could have an M/SM that was converted from gas to propanr at some time..Sounds like a SM to me.The belt pulley thing is of no issue. That was an option that not all tractors had. The lever on the left side is an M/W live pto hand clutch.Pull back on it,the foreward motion will stop,pto will continue to run. snap it foreward and resume foreward motion.We need some picks to help you better.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
