Posted by 88-1175 on March 21, 2018 at 13:32:24 from (98.239.189.101):
back in the 80s and early 90s I helped a few guys get abandon oil wells,repair them,and start pumping them again.my son seems interested in trying to inquire about starting them up again.the wells haven't been pumped since ,I would guess mid 90s.im in northern wva and I know of approx. 40-45 wells that are not being used,and their locations.i also know of a few abandoned cable drill machines too.sssoooo.......how would a person go about finding out who owns these wells ??,would there be records at a bureau or agency on their ownership,and some records of their barrel production ??.how many barrels per day would justify looking into this further ??.these are located on the wva-pa state line.i do know that back in the time I helped we did not have to capture the waste/brine,but it now has to be captured,or so I was told....the guys I helped are now dead and it appears no one seems to be knowledgeable/interested in the useage of them...where would you start ???.also some have been idle since the 60s too...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
