Posted by rtr on March 28, 2018 at 07:43:29 from (205.174.143.2):
Ok Guys..........I need some help loading a tractor (1952 Styled John Deere G) that has been sitting in some hedges for around 15 years. It will be a pretty much straight pull on flat ground from the back yard to the front so it shouldn't be too bad. The old man doesn't want us in the back yard because he says its always wet back there and plus there are too many bushes and sheds in the way to get a pickup back there. We could take our farm tractor or skid steer back there to tow it out but it would risk getting stuck or tearing the yard up. My plan is that winching it to the front yard/gate then we can hook to it and go. Tires are up and holding air. Only problem is that I only have a 4.000 lb Smittybilt Winch mounted on my utility trailer. It works find for small stuff but probably not for this.....especially at a really long pull. Are there ways to rig it up with a block, pulley, etc. that will make it double its power? See attached diagram for more info.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
