Posted by super99 on July 28, 2018 at 19:12:43 from (74.36.75.185):
I bought an old Walden Blade that I want to put on my 1850. The clamps that hold the blade to the frame are gone, I'm going to have to fab up something to use it. Not sure about finding a piece of pipe that will fit over the blade frame to make new ones, rough measurement is 4 1/4" pipe diameter. Wondering about just using a piece of heavy angle iron and weld on flanges for the bolts to go thru. Looks like all the force when pushing will be on the blade frame, the clamps just hold it in place. Has anyone had or seen one on a Oliver before? Wondering about bolting the rear of the frame to the rear axles. Oliver axles have 6 holes cast into the axles, are they strong enough to bolt up there, or do I need to put bolts outside the axles to take the strain of pushing dirt? The holes in the rear mounting plates do not match the holes in the axle, but the plates do not extend far enough past the axles to just bolt it up, looks like I will have to do some modification to the rear mount also. Is all of the push force on the axles or did they have something to fasten onto the drawbar when pushing?? I guess I never have seen one close up mounted on a tractor, just thought they looked like they would be quite the asset to move a little dirt. Chris
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
