Posted by notjustair on August 25, 2018 at 22:11:17 from (174.78.109.166):
Some may remember I recently bought a retired pumper truck (on a ‘64 Ford F600 chassis) to put a bale bed on and make a chore truck out of. It has been very well cared for a runs like a top with no leaks or odd sounds. When I bought it the thing had just over 2200 miles. Total.
I kept thinking about that mileage and just couldn’t believe it penciled out to replace the truck. I know that it is old, but nothing is worn on it and parts are still readily available. When I picked it up it was in one of the volunteer’s barns. He said he sure hated to see it go because they liked the pump on it so much better than their new truck because it primed easier and was more powerful.
Here our VFD has a pumper truck as well although I’ve never seen it. They just use pickups with bumper mounted sprayers and backpack blowers to put out field fires, which is about all they see. It brings me to my question. Are departments required to replace machines due to age regardless of wear and use? When I drove school buses we couldn’t run them past 19 years unless we had special situation permission from the state. This seems like a time a county ought to get that permission.
I got the title in the mail the other day. It had been retitled in 1991 when districts were reorganized. It had 1667 actual miles then. In the following 27 years she got about 600 more. That is just amazing to me - it’s like a little old lady story with a Ford Falcon as the car...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
