Posted by John in La on September 16, 2018 at 18:02:05 from (24.158.216.181):
Lets start with I am not easy on a brush cutter. I feel if the tractor can bend the tree over it ought to be small enough for a brush cutter to eat it. So I replace more than my share of shear bolts. I am using a Howse 5 foot cutter that has a cutting capacity of up to 1 1/2 inches per the manufacture with a 55hp gear box.
Rather than get off my butt and cut these trees down with a saw I am looking at installing a pto clutch and doing away with the shear bolt. We are not talking about cutting a grove of trees. More like might come across 3 or 4 trees per acre.
I assume you just install them with grade 8 bolts and cut the drive shaft to fit the shorter length.
Then I went to find one and found a big price differance in different brands.
With the second one costing almost 3 times as much there has to be a differance but for the life of me I can not find much of a differance in the discription. So school me on these PTO clutches.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.