Posted by 1939farmall on December 02, 2018 at 17:41:54 from (108.86.123.108):
In Reply to: Help 1939farmall posted by Geo-TH,In on December 02, 2018 at 17:19:45:
Go to your earlier post. I answered some of your questions there. All your testing should be done with the modem disconnected. The reading your getting when you plug the modem in is perfectly normal and just indicated the modem is working. Yes the sound you hear when you plug the modem in is it making an audible tone you can hear through the meter as it tries to go into sync with the equipment in the central office.
Is the last pic with the modem unplugged? If it is then it suggests you have a short on the line which would go along with a stress reading of 10. The harder the short is the lower the stress reading is likely to be. If you took that reading with the modem plugged in than it indicates nothing. unplug the modem and test again. Hard trouble like short, grounds, or open are relatively easy to isolate once you get the hang of the meter.
With the modem unplugged go to the interface box and disconnect the incoming wire. Retest which wire had the short on it? If its on your side of the interface disconnect the house wires one at a time till you find the one with the trouble. If its on the phone company side theres not much more you can do except call them.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
