Tractor Talk Discussion Board |
Re: Re: changing oil brands
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi. on September 05, 2001 at 11:56:52 from (208.32.164.127):
In Reply to: Re: changing oil brands posted by Bill Smith on September 04, 2001 at 15:48:54:
Hi Bill, The problem i see with your post is, that all the mfg's. just put bids out, and get an oil made for them. I some times stop at a GM dealer and let them change my oil. If i tell them 10w30 they use GM oil that they have in bulk, (Mobil at the moment) and if i tell them 5w30, no problem, they go to their parts dept. and get it out of cans, and it's Quaker State. Do you think they would change brands "IF" it would hurt the cars they put it in??? A lot of these cars are on warranty, and GM or any other mfg. would not put oil in their engines that would cause them problems. Over the years GM has had several mfg's. make their oil, so really you need to use the right spec. oil not so much a certain brand. I still don't think changeing oil brands is a big deal, and it has proven out in my own expierence, and the expierence of my extended family, who do own brand new cars, on down to older cars. I'm probably the last one of them who still changes my own oil on a reg. basis. Most of them stop where it's convinent, and aren't brand conscience at all. I'm not saying a particular engine won't use more of one brand oil than another, but i am saying i don't believe one brand will cause rapid wearing (or wear out) of an engine just because it has had another brand in it since new. Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|