We are currently in the midst of an ice storm that has already knocked out power around the region. We are on wait and see status to see if we go dark or get lucky.
So I'm still in the planning phase of what I will be doing if and when I get a generator. My meter is mounted on a Square D distribution panel, which itself has breakers in. This feeds the 200 amp service panel in the house, plus an additional 100 amp service panel in the horse barn. The house panel is full to the gills and even has a few doubles installed. The folks who built this went wild with the electric service. Living room alone has at least 15 different switches, plus nearly that many outlets. Would love to know what the electrician who wired it was thinking......for him it was either a wet dream or worst nightmare depending on his attitude.
Anyway, it finally occurred to me the best place to install a sliding lockout switch would be in the meter's panel box, since all juice flows from that, giving the most flexibility, plus is has open slots to use, and we have access to it from the outside to run the wiring.
So in the midst of this ice storm, I go out to take a look and find this......a panel encased in ice. In the event of an actual outage and I needed to hook up the generator, I'd have to find a way to melt the ice to get it open to flip the switches. If the power was out, I could probably pour warm water on it to melt the ice, but pouring water on a service panel doesn't sound like the smartest thing a person could do.
So I suspect the Generlink, if you can hook it up while encased in ice, would be a good fit for me.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
