Tractor Talk Discussion Board |
Re: massey harris 101 super lever
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on September 13, 2001 at 19:22:08 from (209.47.89.100):
In Reply to: massey harris 101 super lever posted by D. Harrell on September 13, 2001 at 17:19:03:
That lever is activated when you put the tractor transmission shift lever into the "B" position (pretty much another neutral position) on the shifting platform. It is part of the "Twin Power" feature which was a system which allowed the governor to enable the engine to rev higher when the tractor was doing "belt work", hence the B on the shifting platform. I believe your tractor decal should read 101 Super Twin Power. If you get someone to sit on the tractor and put the tranny into the "B" position, you will notice that the little lever you mention jumps forward (or back, I can't remember). There would originally have been a control rod between this little lever you speak of and a control cam on one of the shafts on the side of the governor. It (the long shaft and the little cam) is obviously missing on your tractor. I'm not exactly sure how this sort of "bypassed" the governor for throttle control at the governor end, but it did. I have two 101 Twin Power Juniors. The first one was like yours, I saw that little system there and could never figure it out. When I got the second tractor, it was on and hooked up. After I restored the tractor, I never put it back on since I wasn't doing any belt work and also it was just another linkage in the way.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|