Posted by JohnV2000 on June 14, 2019 at 11:29:57 from (174.229.128.150):
Just got my carb kit in the mail.
It has a lot of little seals and a couple jets. As far as I can see, my main Jet looks pretty good, and I do not see any major wear or damage to any of the other jets.
Unless someone says otherwise, I am inclined to not replace any of the jets. This is also following the advice of several forum members who told me to stay simple, although I do want to do a thorough job and learn about carbs, so no easy way out for me.
The numerous small seals and bushing like things are a different story. Is it worth replacing them or just leave the old ones in?
I feel a little silly buying a whole carb kit and only using the two big gaskets (carb to manifold and the main gasket between the two halves of the carb).
I also have a well vent jet on order (C77-18-22 size) that should work well, since my well vent jet was damaged and got further damaged by removing it. In hindsight, I should not have tried removing the well vent jet, it was a mistake, but once I started removing it and damaged it, it had to get all the way out. I just got a little over eager to work on the carb I guess. I will take it slower from now on.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
