Tractor Talk Discussion Board |
Re: Steam whistle air pressure?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on December 11, 2001 at 19:49:56 from (64.12.103.169):
In Reply to: Steam whistle air pressure? posted by Robert in Md. on December 11, 2001 at 19:16:38:
some whistles were made for specific pressures. they are usually marked if they are around the valve area or the Nut part.Some others are not pressure specific, but most are adjustable if you take off the top nut or final, you can look and see how to make the bell part go up or down. You can put a ball valve inline with a gauge hooked up to a T fitting and try the whistle at an infinate pressure range. Run full pressure to the valve and then have the gauge on the down wind side of the valve and have the whistle hooked up there also.adjust the valve to where the whistle sounds nice and note the air pressure on the gauge.If it doesn't sound good adjust it. There you go!
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|