Posted by jimtrs on September 04, 2019 at 09:34:07 from (73.16.69.78):
In Reply to: Hey Kubota Gurus posted by jeff nwoh on September 04, 2019 at 07:12:06:
Quoting Removed, click Modern View to see
Don't have to be a Kubota Guru to answer this one. As stated in other posts, extremely unlikely. I mean i guess by chance they might work, but you need to go through all the motions to find out.
Janicholson got it right for you
Quoting Removed, click Modern View to see
And yes it is all trial and error with the new parts in hand. Put it together, check, take it apart. Add / subtract shims, put it together, check, take it apart. The first time you might say wow this will take me forever. After a couple of times you'll be doing it in the matter of minutes.
There is skill involved in setting pinion and ring gears. Preloads and backlash are pretty straight forward. Depth is another thing. You can have preloads and backlash correct, and still be way off on depth. You need to accurately evaluate each time to get it correct. Now with that being said, it's not a car driving at highway speeds.
BUT before you go to far, the biggest question of all .....
Why did it blow up in the first place? If due to say wrong tire size in 4 wheel drive, you may be doing it all over again, sooner than you want. Not to mention the cost of parts. You really want to answer this question first.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
