Tractor Talk Discussion Board |
Re: Re: desperate for chains, snowdrift, and clutch advice
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by THANK YOU! - john on January 15, 2002 at 10:19:48 from (142.32.208.234):
In Reply to: Re: desperate for chains, snowdrift, and clutch advice posted by Big Jim on January 15, 2002 at 10:03:30:
Thank you all very much for your valuable knowledge. I will pick up the free set of chains. They are a ladder-type pattern. The set I was going to buy were H pattern. I guess I will have to join the x links so they dont get settled down in the tread. As I may have told you, I have never used chians like these before (large equip). Naturallay assuming (bad) that I would tighten them with bungies cords, I now know this is the last option. I saw on the internet these tensioners with heavy spring that form a spoke-like pattern. Do any of you have good ideas for this purpose that are cheap? How about turnbuckels or some kind of similar tightening device? I have been told to get the inside of the chains as tight as possible, then do the outside. This is all I know. Once I get them on, do I drive around a bit, let them settle and them tighten them? Or drive forward just a touch, and tighten , and repeat this until they are very tight? I will try to attach a 45 gallon drum with rocks on the back of the tractor somehow, but unsure how to do this. This is all I have readily available and cheap. The draw-bar has been taken up by the snowblower attachment, and there isnt much other readily accesible "meat" to attach this kind of weight to. I have a friend how is a welder and coul;d possibly get him to weld me up something like a frame. I like the idea of wheel weights too, are you guys suggesting something liek steel plate cut to diameter of inside rim? Thank you all very much for your comments. Much appreciated - happy farming! and hoping for good summer growing seaon. john
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|