Tractor Talk Discussion Board |
Re: Experiences With Engine Heaters?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold Hubbard on January 22, 2002 at 04:53:28 from (216.114.175.235):
In Reply to: Experiences With Engine Heaters? posted by TMAC on January 22, 2002 at 02:49:23:
In my opinion the best heater is a "frost plug" type. This inserts directly into the block ,either screwing into an existing tapped hole or locking into a frost plug hole like a boiler plug. It heats the coolant directly, without any losses into the air. My second choice would be a tank heater, which is plumbed up with short hoses. The dipstik heaters just fry the oil, and the only advantage I can see to the magnetic ones is being able to use them on more than one engine. Around here, many of the loggers and constuction guys use a set of hoses with quick connects that hook right into the heater hose on their pickups. Works anywhere you can drive a pickup to, and you can hook up booster cables at the same time if your battery is a little weak. This setup will warm up even a big engine fairly quickly, but don't expect to sit in the truck with the heater running and stay warm, all the heat is going into the other engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|