Posted by JohnV2000 on May 31, 2020 at 05:30:52 from (71.61.100.67):
I am getting close to ordering some new wiring for my Farmall Super C, but I was wondering what the proper way to use different color wire is.
It sounds like a simple question, but what I mean is, there are probably 7 or 8 different wires on the tractor, and I do not think I could find 7 or 8 different color wires. Should I just try to use different colors for the longer wires, and the wires going to and from the dashboard area so I do not get confused when following the wire?
Also, I am not going to try to get original type wire, I will just buy modern automotive wire. Maybe in the future I would consider doing a complete restoration with original, authentic 1950s style wire, but for now, I will not do that.
As for wire gauge, I believe people have mentioned 10, 12, and/or 14 gauge wire. Any other advice for wire gauge?
One more question, and I hope its not too many questions, but what about the battery to starter and battery to ground wires? Those look much thicker, what are the specifications on those?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
