Posted by P57Mustang on June 29, 2020 at 19:06:44 from (107.77.206.51):
Good evening everyone, I recently purchased a 1963 MF 65 industrial loader tractor with the Perkins 4-203 diesel engine. The older gentleman who sold it to me was in poor health and could no longer get down to work on it. He was told it needed a new water pump and fuel filters by the previous owner. He had it delivered to his house on a rollback and installed a new water pump and hoses. He routed the lower hose wrong and the fan belt wore a hole in it and he took it back off. I started it and drove it onto and off the trailer full of oil but without water. I didn’t run it for more than 2 minutes each time with a 3 hour haul in between. When it was idling, it sounded like either a rod was knocking or an injector was hammering, however when I revved it up the noise quit. It was blowing bluish-white smoke the entire time. I just installed the new lower hose this evening and when I started filling the radiator, water started coming out of the exhaust. I pulled the dipstick and the oil is not over full or milky, granted I didn’t attempt to start it. I’m guessing either a bad head gasket, cracked head, cracked block, or bad piston sleeve. It will be a couple weeks before I can drop the loader and pull it into my shop and tear into it to see. I was wondering if any of y’all had any insight as to the most likely issue. Is there any possibility that he installed the water pump wrong or left out a gasket or something that would allow water to flow directly from the water pump into the exhaust? I will greatly appreciate any information. Thank you.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
