Posted by Will Herring on July 02, 2020 at 17:33:59 from (50.106.214.113):
So an update on this WD-45 that has been sitting for 10 years in a dirt floor barn at my cousin's place without running... I spent today working on this tractor one more time, and after a 4 hour marathon session in the heat, I finally had success! Even though it was hot and humid and miserable all day, it was worth it. I took a bit of video of the event and of the engine running:
If you listen to the video, it does seem like there is some engine flutter... Not sure if I have a miss on one cylinder, or if the exhaust manifold has a leak or one of the valves is sticking or what, but it makes a pretty nasty thumping sound from time to time while running with the throttle cracked open a little bit. Also pretty easy to get it to backfire. But hey, it runs, so it's a start!!
So what all did it take... I filed the points, cleaned the gas tank (there was a rotting piece of wood in there that was causing lots of trouble), new gas cap, new sediment bowl assembly and gaskets, cleaned the carburetor, new carb gaskets, fresh gas, topped off fluids (1.5 gal of antifreeze, 1 gallon of hydraulic fluid between the loader and the rear rams, 2 quarts of oil for the motor), new gear shift boot, charged battery and cleaned all of the battery connections in the ignition side... And then today, it finally came to fruition!
Also someone had asked me awhile back about the wheel weights, so I took some pictures of the markings on them.
Thanks for the assistance along the way; you guys have been fantastic as always!!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.