Posted by crookedcreekjerseys on March 15, 2021 at 18:45:59 from (174.233.136.0):
A few months back I noticed a pretty salvageable late model ford 3000 with a factory roll bar. I dont usually look for tractors this small but after driving by for a few months I started thinking that would be a pretty sweet little companion for my ford 5610 series II I have in my collection. Especially if I were to toss a canopy on the roll bar. Well that snowballed while I was driving into this question, the year is 1992 and your pretty much a blue guy when it comes to tractors, implements can vary. You have a Ford 5610 series II with a cab, late model Ford 3000, Ford 4630 with 4x4 and a loader, and a New Holland L455 skid steer. You run a dairy with a 40 cow free stall and feed on a outside concrete paddock in H bunks. Could you make it work and if you think you could what lineup of equipment would you pair up to this line of tractors. Id imagine this would probably be a part time operation at that time. Dont be afraid to be detailed. Throw in what model truck youd have if you want.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.