Posted by 1206SWMO on May 30, 2021 at 14:03:47 from (184.63.252.40):
Yesterday I and a friend attended a large estate sale northeast of McCune,Kansas..It was cloudy for lots of the sale and the temp was around 60 degrees which is pretty cool for this time of the year.....There were 17 Oliver tractors and crawlers plus 17 Oliver plows...Sadly,the scrap man got all of the plows and some of the tractors.
Its going to take 5 posts to get all the pictures and results on here...Several of the pictures aren't too good..There was a pretty good crowd and they ran out of food long before the sale was over. The non running 1950-T Oliver sold for $3,000... The non running Oliver 1900 with 4-53 Detroit sold for $1,900. The non running 1800 Oliver diesel sold for $1,300. The non running 1800 Oliver LP sold for $1,100. The non running 1800 Oliver gas sold for $900.. The non running Oliver 1750 diesel sold for $1,450.. The non running late 1920's 18-36 Hart Parr sold for $4,900...It was a real decent tractor with the engine being free and probably would run with just a little work..A friend 25 miles east of me bought it.. This nice 80 Oliver standard sold for $2,300...It would run with some minor work. This running 88 Oliver sold for $1,300...One new tire was already mounted and the other needed mounting...It used to be a puller. This non running 70 Oliver puller sold for $1,750..Those 11 x40 Wards tires work good for pulling.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.