Thanks Greg, I'm flying blind with this reply to you (because I don't understand how a generator really works) but I did some simple continuity tests (which I I generally understand). With reference to the last section of your link you provided (A or B circuit ??) .....
First, each of the two brushes (inside the far end of the generator) individually show continuity to ground (the generator case). This is not involving the F or A terminals on the generator, just a test from the brush wire itself to the case. Then, the two brushes show continuity between them as well in a separate check. I am assuming that one of those brushes should be insulated from the case, is that correct?
The field terminal on the generator has a wire leaving it inside and it goes to one of the big coils that surround the armature. That generator field terminal tests continuity to ground (the generator case) and also to both brushes in separate tests.
The armature terminal on the generator is wired directly to one of the two brushes. That armature terminal tests continuity to ground (the generator case) and also to both brushes (just like the field terminal did).
Something doesn't sound right to me if your link is saying that one of the two brushes should not ground to the case (or is not insulated).
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
