Posted by BarnyardEngineering on September 12, 2022 at 07:48:40 from (161.69.123.10):
In Reply to: Need help to ID Farmall posted by ramblerdad on September 12, 2022 at 06:54:46:
You have a tractor built from parts. A regular "Johnny Cash" machine, referencing the song "One Piece At A Time."
Y is 1953.
L would be 1942 or somewhere up in the 1960's, like 1966.
I might be a T which would be 1950. I would be 1937 or 1938 which is before M production even started. Odds are you don't have pre-production parts. The other option is 1963, which is after even 560 production stopped.
F would be even further back in the 1930's well before the M was even a gleam in Raymond Loewy's eye. So it would have to be 1960, which I guess is possible as the 560 was still in production at that time and rear axle housings from a 560 would fit an M.
The serial on the engine is pretty low, and I think it's out of a W6. What's the date code on the block?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.