Posted by D Slater on September 12, 2022 at 12:45:26 from (184.13.66.209):
In Reply to: Need help to ID Farmall posted by ramblerdad on September 12, 2022 at 06:54:46:
Engine serial number started out being a 1948 W-6 engine gasoline fuel. Engine was early in year so may have a previous year letter on block. Look more to rear of where the serial number was between metal side cover and head. Unless they cut a hole and used the SMD hood the front bolster would need changed for a gas hood to fit, unless a SMTA one or modified hood. F castings were from 1960 so they would need to be from a 560 if the letter is correct. One problem if a F is on the tank and steering support it would need to be a later replacement part from IH. None were used on a tractor that could work after 1958. Clutch housing is a late enough so it and a gas SM that late used the same housing. Uses a 3 bolt starter. Does it have a diesel starter or other? Does it have a hydraulic unit under fuel tank? Diesel fuel tank will have two line holes in bottom, gas just one. They could use diesel tank by plugging the extra. Could the I be a R missing part of it?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
