Posted by redforlife on October 19, 2022 at 21:04:02 from (174.210.169.13):
In Reply to: Head gasket? posted by rubicon1234 on October 19, 2022 at 20:36:11:
The best way I know of, is let tractor sit for a lengthy spell (several days) before doing an oil change. And loosen the drain plug up enough for it to just drip (don't take it out). Just loosen enough for a drip. If what drips out is water, and un- mistakeably green, then it is antifreeze (coolant). Not condensation. Of course this has to be done without starting or warming up the engine before loosening the plug.
If you just took the dang plug out, and paid no attention other than, I thought some of that might of been water, then you just missed your best chance to figure things out.
The water will settle to the bottom of whatever you drained the oil in. The problem with that is though, whatever you drained it in, likely don't have a drain plug in it.
So you can either put plug back in, do a coolant system pressure test, and let tractor sit for awhile, and see what (if anything) shows back up in the pan. Or you can just complete the oil change, operate it for awhile, and check things out again as mentioned above, the next time you do an oil change.
As to dry sleeves or wet sleeves, I can't answer that one. If I had to guess, I'd say dry sleeves, but that's just a guess, as I don't know for sure on this model.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.